Diferencia entre revisiones de «Modalità CNC»
De ArcoWiki
(Página creada con «'''CNC Mode''' is the state of the CMM that allows automatic movements. The DMIS enhance two different attitudes based on the CNC Mode selected: *MODE/PROG,MAN...») |
(Sin diferencias)
|
Revisión actual del 10:04 1 jun 2018
CNC Mode is the state of the CMM that allows automatic movements.
The DMIS enhance two different attitudes based on the CNC Mode selected:
- MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands.
- MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands.
The custom canned cycles (Non-Dmis standard) enhanced by ARCO, if set, are also executed in AUTO mode.
